Quick Installation

The INdispenser installs quickly and easily on any tile or plastic wall surface commonly used in
bathrooms or showers. All materials for both 'hard' and 'soft' mounts are included.
Once mounted, fill the solution chambers and start enjoying the INdispenser. Eight pre-printed and two
blank labels are provided for the identification slots.
You decide what type of bathing solutions you want and which goes where.

Mounting to wall with adhesive (supplied)

Step 1

Apply double sided tape and adhesive in separate positions on the raised surface on the back of the INdispenser.

Step 2

Firmly press the INdispenser against the wall at the location you want. (Make sure the wall surface is thoroughly clean and dry) Hold for 2-3 minutes and allow 24 hours for adhesive to bond.

Mounting to wall with screws (supplied)

Step 1

Locate the exact location you wish to mount the INdispenser by using the back as a guide. Use a marking device to mark through the pre-drilled holes to locate your drilling points.

Step 2

Drill holes.

Step 3

Attach backplate to wall using screws provided.